|
Dependable. Easy
to Use. Cost Effective.
To complete your
laminating system, LEDCO has designed the brand new High Speed "Finish
Line" Cutter. This reasonably priced cutter has been designed to
be used with either the HD-25 Workhorse laminator or any other laminating system.
An integrated fiber
optic sensor precisely activates the shearing blade as it senses the leading
and trailing edges of each sheet to be cut. Speed is easily adjustable
up to 150 FPM without stopping the machine during operation. The upper
and lower cutter blades are interchangeable, making the cutter economical
to operate.
A feed table supports
the web during the threading, and handy feed guides are conveniently adjusted
from side to side to ensure precise web travel into the cutter.
Unlike other competitive
equipment, compressed air is not required. The easy-to-use keypad adds
to the all over user friendliness of this cutter. A standard 115V, 15
amp outlet is all that is needed to begin operating this sleek, new, high-speed
machine.
High Speed
Cutter Standard Features
- Variable speed - The
cutter operates at any speed up to 150 FPM (actual output may vary depending
on number of cuts per minute).
- Levers to open and close feed rollers
- The levers hold the rollers
open while you thread and straighten the web.
- Feed table with adjustable guides
- The feed table supports the web during threading and the guides
are easily adjusted to ensure precise web travel.
- Total electrical operation -
The
unit is very convenient, only requiring a 115V 15 amp outlet or depending
on model, 208V-240V single phase, 50/60 cycle, 13 amp outlet.
- Active mode variables displayed
- The control panel displays
all settings before, during and after operation.
- Speed adjustment during operation
- The speed can be easily
adjusted during operation.
- Interchangeable cutting blades -
If the blades should ever become dull, they can be interchanged
top to bottom for a new cutting edge.
High Speed Cutter Optional Equipment
- Stand - An extruded aluminum
stand is an option. There are also locking castors available for fast
and easy setup.
- Variable speed power exit table - The
speed can be adjusted from 0 - 150 FPM.
High Speed Cutter Specifications
| Maximum web width |
30"
|
| Speed |
0-150 FPM
|
| Maximum cutting thickness |
up to 50 mil
|
| Dimensions |
53L 20H 27D
|
| Electrical |
115V
12 amps
|
| Electrical connector |
NEMA 5-15R
|
|
Price
|
|
110 Volt |
$16,919.00 |
|
220 Volt |
$17,216.000 |
Prices subject to change without notice
Freight: FOB Ship point
We accept all major credit cards
Revised
January, 2009
Back to Top
GWJ co
Hacienda
Heights, CA 91745
Phone 626-336-1134
800-336-1138(USA)
Fax 626-336-2409
Copyright ©
1997-2009 GWJ Co. All rights reserved.
Other products and companies referred to herein are trademarks
or registered trademarks of
their respective companies.
| 
